Donning and Removing PPE for Non-Cleanroom Environments
The following recommendations are provided by the CDC
SEQUENCE FOR PUTTING ON PERSONAL PROTECTIVE EQUIPMENT (PPE)
The type of PPE used will vary based on the level of precautions required, such as standard and contact, droplet or airborne infection isolation precautions. The procedure for putting on and removing PPE should be tailored to the specific type of PPE.
1. GOWN
- Fully cover torso from neck to knees, arms to end of wrists, and wrap around the back
- Fasten in back of neck and waist
2. MASK OR RESPIRATOR
- Secure ties or elastic bands at middle of head and neck
- Fit flexible band to nose bridge
- Fit snug to face and below chin
- Fit-check respirator
3. GOGGLES OR FACE SHIELD
- Place over face and eyes and adjust to fit
4. GLOVES
- Extend to cover wrist of isolation gown
HOW TO SAFELY REMOVE PERSONAL PROTECTIVE EQUIPMENT (PPE) EXAMPLE 1
There are a variety of ways to safely remove PPE without contaminating your clothing, skin, or mucous membranes with potentially infectious materials. Here is one example. Remove all PPE before exiting the patient room except a respirator, if worn. Remove the respirator after leaving the patient room and closing the door. Remove PPE in the following sequence:
1. GLOVES
- Outside of gloves are contaminated!
- If your hands get contaminated during glove removal, immediately wash your hands or use an alcohol-based hand sanitizer
- Using a gloved hand, grasp the palm area of the other gloved hand and peel off first glove
- Hold removed glove in gloved hand
- Slide fingers of ungloved hand under remaining glove at wrist and peel off second glove over first glove
- Discard gloves in a waste container
2. GOGGLES OR FACE SHIELD
- Outside of goggles or face shield are contaminated!
- If your hands get contaminated during goggle or face shield removal, immediately wash your hands or use an alcohol-based hand sanitizer
- Remove goggles or face shield from the back by lifting head band or ear pieces
- If the item is reusable, place in designated receptacle for reprocessing. Otherwise, discard in a waste container
3. GOWN
- Gown front and sleeves are contaminated!
- If your hands get contaminated during gown removal, immediately wash your hands or use an alcohol-based hand sanitizer
- Unfasten gown ties, taking care that sleeves don’t contact your body when reaching for ties
- Pull gown away from neck and shoulders, touching inside of gown only
- Turn gown inside out
- Fold or roll into a bundle and discard in a waste container
4. MASK OR RESPIRATOR
- Front of mask/respirator is contaminated — DO NOT TOUCH!
- If your hands get contaminated during mask/respirator removal, immediately wash your hands or use an alcohol-based hand sanitizer
- Grasp bottom ties or elastics of the mask/respirator, then the ones at the top, and remove without touching the front
- Discard in a waste container
WASH HANDS OR USE AN
ALCOHOL-BASED HAND SANITIZER
IMMEDIATELY AFTER REMOVING
ALL PPE
HOW TO SAFELY REMOVE PERSONAL PROTECTIVE EQUIPMENT (PPE) EXAMPLE 2
Here is another way to safely remove PPE without contaminating your clothing, skin, or mucous membranes with potentially infectious materials. Remove all PPE before exiting the patient room except a respirator, if worn. Remove the respirator after leaving the patient room and closing the door. Remove PPE in the following sequence:
1. GOWN AND GLOVES
- Gown front and sleeves and the outside of gloves are contaminated!
- If your hands get contaminated during gown or glove removal, immediately wash your hands or use an alcohol-based hand sanitizer
- Grasp the gown in the front and pull away from your body so that the ties break, touching outside of gown only with gloved hands
- While removing the gown, fold or roll the gown inside-out into a bundle
- As you are removing the gown, peel off your gloves at the same time, only touching the inside of the gloves and gown with your bare hands. Place the gown and gloves into a waste container
2. GOGGLES OR FACE SHIELD
- Outside of goggles or face shield are contaminated!
- If your hands get contaminated during goggle or face shield removal, immediately wash your hands or use an alcohol-based hand sanitizer
- Remove goggles or face shield from the back by lifting head band and without touching the front of the goggles or face shield
- If the item is reusable, place in designated receptacle for reprocessing. Otherwise, discard in a waste container
3. MASK OR RESPIRATOR
- Front of mask/respirator is contaminated — DO NOT TOUCH!
- If your hands get contaminated during mask/respirator removal, immediately wash your hands or use an alcohol-based hand sanitizer
- Grasp bottom ties or elastics of the mask/respirator, then the ones at the top, and remove without touching the front
- Discard in a waste container
WASH HANDS OR USE AN
ALCOHOL-BASED HAND SANITIZER
IMMEDIATELY AFTER REMOVING
ALL PPE
One Company. More Solutions. High-Tech Conversions Is Now Hospeco Brands Group
High-Tech Conversions has officially transitioned to Hospeco Brands Group, bringing our teams, expertise, and expanded product offerings together under one unified company name.
Introducing NuBlend™ Heavy-Duty Wipes: Grab the Flat Pack. Skip the Mixing. Get to Work.
Hospeco Brands Group introduces NuBlend™ Heavy-Duty Wipes, combining industrial-strength cleaning power with the convenience of an oversized, ready-to-use pre-moistened towel.
High-Tech Conversions is Now Part of Hospeco Brands Group
As part of our continued integration with Hospeco Brands Group, High-Tech Conversions will soon begin transitioning its company identity to Hospeco Brands Group.
All-Purpose Cleaner & Degreaser for Professional Facilities: Meet EvoGreen™
Meet EvoGreen™ All-Purpose Cleaner & Degreaser, a high-yield concentrate for professional facilities, heavy-duty degreasing and everyday cleaning.
Why Is Handwashing So Important?
Proper handwashing is one of the simplest yet most effective ways to protect yourself and others from spreading germs.
Hospeco Brands Group Canada Janitorial Supplies. Now online!
Hospeco Brands Group is proud to welcome Canadian customers to a new website experience.
Why Cleaning Industry Advocacy Matters to Every Facility We Serve
The cleaning and facility solutions industry doesn't just respond to change. It helps shape it.
Extend Brand Awareness with Custom Durable Products from Hospeco Brands Group
Branding does not stop at signage, websites, brochures, or sales materials. The strongest brands reinforce their identity at every customer touchpoint, including the everyday products people use throughout a facility.